Dryer Part

The dryer part is the process for drying the sheets that were dehydrated in the wire part.
We use yankee, after, and band dryers.

Yankee dryer

This dryer has a cylinder whose diameter is as large as 2 m or larger. It dries the sheets by the heat generated by the steam supplied to the cylinder. The dryer surface is polished so that the dried paper surfaces will become glossy.

After dryer

This is a dryer with many cylinders that can dry the sheets uniformly by removing moisture a little at a time.

Band dryer

This dryer dries the sheets by blowing hot air from above and below using an endless wire mesh. This method adds a texture similar to non-woven fabric.

Inquiry about this technology

Inquiry Form

Go to top of the page